Wuxishi Da Tang Drying Equipment Factory
Home > News > Content
Horizontal Drier Principle
- Jul 11, 2017 -

Now more common is the vertical dryer and horizontal mesh belt dryer, vertical dryer is a few years ago the use of coal baking the main equipment, Horizontal Drier because it has many shortcomings such as finished powder too easy Fire, etc., drying effect is not very good, and now the new production of basic users will choose horizontal dryer. Horizontal dryer is mainly based on mesh belt dryer, Horizontal Drier if the briquette manufacturers are now using the vertical dryer equipment drying efficiency is not high, within the conditions allowed to find the best professional technicians Transformation to reduce the loss of failure, Horizontal Drier or replaced with a new type of efficient and environmentally friendly horizontal replica dryer.

Mesh dryer is the use of mesh belt two-way transport principle, the use of hot air furnace heating or flue gas drying medium for drying. Is a batch, continuous production of drying equipment, Horizontal Drier the main principle is to spread the material evenly on the mesh belt, mesh belt with 12-60 mesh wire mesh belt, dragged by the drive in the dryer to move back and forth, Commonly there are three, five, Horizontal Drier mesh belt dryer mainly by the head frame, tailstock, the middle frame, traction chain, network chain, rail, automatic tension device, automatic heating equipment and other components.

The briquettes are crushed into briquette containing a lot of water, and the upper part of the dryer is introduced into the upper layer of the dryer by the top of the dryer. Horizontal Drier The net belt runs smoothly to the rear of the dryer, flows into the lower part along the chute,Horizontal Drier  Nose, so back and forth, baking in hot air baking, and gradually dry, sent by the tail of the machine.

With automatic tension device, chain plate running smoothly, Horizontal Drier flip freely, thus solving the chain, card chain, deviation and so on.

Sieve plate (not an ordinary steel mesh belt) Use heat-resistant steel into a mesh, with high strength, not easy to deformation, good ventilation. Horizontal Drier This feature effectively avoid the steel wire mesh due to long-term heat bearing deformation caused by the problem, can greatly reduce the use of briquette in the deformation of the network with the resulting maintenance costs.

Chain plate by the speed motor drive, Horizontal Drier according to the need to adjust the speed of operation, according to the characteristics of coal itself, control the drying time, in order to achieve the best drying effect.

Kiln body temperature display, Horizontal Drier easy to master and control the kiln temperature.

Kiln inverting machine on both sides of the maintenance channel, easy to carry out maintenance testing equipment.

Hot stove heating using chain furnace automatic heating equipment, automatic coal, automatic slag removal, high thermal efficiency, coal to adapt to wide, Horizontal Drier clean and environmentally friendly, save time and labor.

Equipped with fire protection device, kiln head, kiln, kiln, with three thermocouple, flue inlet with smoke gate, once the mechanical failure, immediately put down the gate, cut off the heat source to prevent the fire.

The use of negative pressure cited wind, Horizontal Drier dust is small, uniform distribution of hot air, air inlet and chimney at the bottom of the ash pool, dust discharge standards, replica two with automatic screw removal device, simple and convenient. Positive pressure blast, dust, Horizontal Drier the production site pollution is serious, and cloth duct easily blocked.

Designed from the end of the low temperature area of the ball, the ball out of the ball, the briquettes from the low temperature gradient heating, high temperature gradient heating, to avoid the formation of 8-10% moisture after the briquettes due to rapid heat and crack, burst, Horizontal Drier The This is designed for the characteristics of briquette itself, Horizontal Drier effectively improving the quality of the production of briquette.

Negative pressure cited wind kiln exhaust temperature ≤ 100 ℃, dust content is small, induced draft fan long life, low operating costs.

The quality and price of the briquette dryer is the most important issue for customers. For those inexpensive netting machines, Horizontal Drier the production efficiency of the briquette equipment production line is reduced and the maintenance cost is increased in the actual use. Mechanical production of the tunnel chain plate tandem dryer equipment in the briquette production in a good running state, the ideal drying effect, Horizontal Drier so that briquette pressure ball machine equipment production to the maximum protection. Horizontal Drier So briquette dryer customers in the purchase price, the quality to be the same measure.